1967 coronet rt quaters

[evanbrendel]

anybody know where to get good quality full quater panels for a 1967 coronet rt?

 

[696pack]

Until ADM begins to make them (and I don't know if they plan on it or not) they all comefrom the same over seas stamper no matter who you buy them from. They vary in quality depending on how old they are as the stamps degrade with time. I would not buy a set without first inspecting them personally to see how crisp the stamp lines are. They are also a thinner gauge than the originals.

This is why you see so many people advertising for original rust free 67 2 door fenders. People buy complete cars for the rear quarters for 67 B bodies. This is also why it is so important to buy a good sheet metal car in the first place with these cars as they are expensive to restore and they typically don't bring as much as a 68-71 like type car.

 

[evanbrendel]

i didnt know that. well its cheap only 700 i figured a 67 rt was waorth 700 its had the dana 60 robbed tho but it has ben hit in the pass quater.

 

[daredevil]

is 66 and 7 metal the same

 

[696pack]

On Coronets the 67 has a faux vent depression on the forward upper part of the rear quarter that the 66 does not have. other than that they are the same.

 

[evanbrendel]

well im sure i can make a 66 work and cut the parts from the 67 because it is hit in the rear part of the quater or maybe straighten it

 

[696pack]

well im sure i can make a 66 work and cut the parts from the 67 because it is hit in the rear part of the quater or maybe straighten it

That is a very common thing to do with these cars/parts.

 

[mopower_333]

there's an nos passenger side one on ebay for $3000....