WTB 1967 Dodge coronet operating lever / Automatic transmission

[Durandal25]

......

I need the lever......

 

[Mike67]

I think I may have one. I won't be back at the shop until Saturday if you don't find one between now and then.

 

[Durandal25]

I think I may have one. I won't be back at the shop until Saturday if you don't find one between now and then.

thanks mike. I’ll probably buy it anyway. I’m going to see if I can get it reproduced

 

[Durandal25]

Team,

This is a very interesting and annoying part to track down. There are two part numbers in question 2883211 and 2880948. Part number 2883211, is a black unit that has a pin that gets tapped in to secure the bottom press in fitting. This part is a break away design and I'm trying to find out if I can get a 3D print of it. If anyone has a NOS part I'll buy it. Mike is looking to see if his column has one intact, but failing that I'm going to get a run made, as I am sure many folks on here would like one......

 

[Durandal25]

Here's a good pic of one

 

[Durandal25]

Mid I can get these pins repopped , whose interested in getting one?

 

[Durandal25]

If anyone has either of the part numbers listed let me know . I’m very serious about getting a run of these done and a copy of the 3D mesh

 

[Durandal25]

MIke67 may have 2880948, white, but I also would like 2883211 too. Anyone? If I can get these re-popped and get a 3D mesh file created.....anyone can get these made locally at a 3D shot out of poly ect.

 

[Durandal25]

So here's another PIN (don't have part number) that came in the 66

 

[Durandal25]

Team

I’m still in the hunt for one of these

 

[Durandal25]

So I bought an entire c body column to get the metal version of the reverse pin. If anyone needs the column and or parts let me know

 

[Durandal25]

Got this one off a C Body column. Not sure if its a fit yet

 

[Durandal25]

Just for the record , here’s the opening on my 67 column for the pin…

adding