Average Joe
Well-Known Member
Looking to sell some extra Big Block parts I have.
440 Block: Bored .040 over the block has been drilled out for 1/2 inch bolts,the casting has been smoothed in the lifter valley,crank area and oil drain passages.
906 Heads: these heads were drilled out to match the block.
Forged Crankshaft ,needs polished.Stock 440 rods
This engine was a friend of mines who bought my edelbrock heads. I was going to put the heads on this block when I realized the bolt difference.I had another block so we took the rotating assembly out and built the other block.The Block and heads have very little run time. when I pulled the engine apart there was metal in the bearings so it needs new cam bearings.
The lifter are hughes engines retrofit hydraulic roller lifters. I had them in my aluminum Hemi block during start up then changed to solid lifters.
They are in the solid lifter box. They have about an hour of run time on them.
Headers: The headers I believe are hooker headers not sure.they have a couple of dents on the tubes.
Valve covers fabricated powder coated black. They have Charger engraved on them. Have some scratches on them.
I would like to sell the block,heads together = 450.00
Crankshaft= 175.00
Rods=50.00
Lifters=250.00
Valve covers=60.00
Two piece stainless valley tray =25.00
Headers=70.00
MSD 6-AL box =100.00
B body rally dash from a 1968 charger, sand blasted has a little pitting no holes.=200.00
I do have some Barracuda sheet metal parts,rocker,drivers frame rail,complete AMD package tray metal if any interest.
Shipping is in addition to anything sold.
I live in Colorado Springs,Colorado
I am looking for a A-body 8 3/4 posi for 67 barracuda.Willing to trade?
Thanks,Joe
If the pics stink I will take more upon request.
440 Block: Bored .040 over the block has been drilled out for 1/2 inch bolts,the casting has been smoothed in the lifter valley,crank area and oil drain passages.
906 Heads: these heads were drilled out to match the block.
Forged Crankshaft ,needs polished.Stock 440 rods
This engine was a friend of mines who bought my edelbrock heads. I was going to put the heads on this block when I realized the bolt difference.I had another block so we took the rotating assembly out and built the other block.The Block and heads have very little run time. when I pulled the engine apart there was metal in the bearings so it needs new cam bearings.
The lifter are hughes engines retrofit hydraulic roller lifters. I had them in my aluminum Hemi block during start up then changed to solid lifters.
They are in the solid lifter box. They have about an hour of run time on them.
Headers: The headers I believe are hooker headers not sure.they have a couple of dents on the tubes.
Valve covers fabricated powder coated black. They have Charger engraved on them. Have some scratches on them.
I would like to sell the block,heads together = 450.00
Crankshaft= 175.00
Rods=50.00
Lifters=250.00
Valve covers=60.00
Two piece stainless valley tray =25.00
Headers=70.00
MSD 6-AL box =100.00
B body rally dash from a 1968 charger, sand blasted has a little pitting no holes.=200.00
I do have some Barracuda sheet metal parts,rocker,drivers frame rail,complete AMD package tray metal if any interest.
Shipping is in addition to anything sold.
I live in Colorado Springs,Colorado
I am looking for a A-body 8 3/4 posi for 67 barracuda.Willing to trade?
Thanks,Joe
If the pics stink I will take more upon request.
