WTB 65 coronet 500 rocker moldings

[EARLY B]

Looking for both sides of the rocker moldings. See many cars without what is everyone doing with them? Please let me know what you have with condition. THANKS

 

[QuickBpBp]

I believe I have one side… Don’t remember which side.. Do you have a picture of what you need so I can verify?

 

[EARLY B]

CCCC

 

[EARLY B]

I believe I have one side… Don’t remember which side.. Do you have a picture of what you need so I can verify?

Added photo's they are about 5" wide and 75" long the rear of the molding usually have the rear wheel well molding transition attached.

 

[QuickBpBp]

Thanks the one I got is straight and thin probably for a different model of a 65 Coronet..Good luck in your search..

 

[EARLY B]

Thanks the one I got is straight and thin probably for a different model of a 65 Coronet..Good luck in your search..

Thanks for looking

 

[65satelliteman]

I SENT YOU A PRIVATE MESSAGE

 

[Big Bad Dad]

I may have one. Will look in the barn today.
EDIT UPDATE >
I had two 65 Coronet 500s way back when I was in high school. This rocker was in the old barn, and "I Think" is from one of them. (Not sure) Here's a picture. Is this what you are looking for? It has a couple of dents, but could probably be repaired for a driver.

 

[BlairCoronet500]

I have a complete set of rockers with the front & rear transition pieces for the wheel opening mouldings with two complete sets of wheel opening mouldings.

 

[EARLY B]

I have a complete set of rockers with the front & rear transition pieces for the wheel opening mouldings with two complete sets of wheel opening mouldings.

Thanks for the reply. I have found some and have them installed.