67 Sat parking bulb question!

[Thunderspeed]

G'day folks,

New 67 Satellite owner here and in the process of going over the car, replacing worn and failed parts, I've come across a broken front left parking lens bulb. The bulb was already blown and as usual was seized and snapped off when trying to remove it. The shank of the bulb is still tight in the socket ... I'm not too concerned about removing it ... been there before, however. When looking at Bulb replacements, they all appear to be bayonet type ... I may have assumed incorrectly but I thought perhaps these were screw in? Does anyone know what these bulbs were originally ... so when I go to remove the shank I'll know to give an inward push and twist before trying to remove ... rather than trying to twist it out and damage the socket any further.

Thanks! ;-)

 

[Dave6T4]

1157 (clear); 1157A (amber). Twist in.

 

[copper67sat]

Bayonet - push in and twist

 

[Thunderspeed]

Thanks gents ... appreciated!

 

[Jerry Hall]

Push in and twist approximately 1/4 turn counter clockwise.

 

[Sam69sat]

If you had to replace the socket these are available.

Dorman 85803

https://www.oreillyauto.com/detail/c/dorman-conduct-tite/lighting---electrical/connectors---terminals/parking-turn-signal-stop-light-connector/3ae1091133c8/dorman-conduct-tite-electrical-socket/cti0/85803

 

[oldbee]

Put a little dielectric grease on new bulb when installing also.

 

[Thunderspeed]

Put a little dielectric grease on new bulb when installing also.

I have a tube of the very stuff ... yes, that was the plan - put some on the shank.

 

[Thunderspeed]

If you had to replace the socket these are available.

Dorman 85803

https://www.oreillyauto.com/detail/c/dorman-conduct-tite/lighting---electrical/connectors---terminals/parking-turn-signal-stop-light-connector/3ae1091133c8/dorman-conduct-tite-electrical-socket/cti0/85803

Awesome, thanks for that!