SOLD 8 3/4 742 case pinion spacer sleeve

[chargehard]

looking for 8 3/4 742 case pinion spacer sleeve

 

[daredevil]

Crush sleeve,check Mancini.

 

[Cranky]

The 742 doesn't use a crush sleeve....but uses a spacer. I'll take a look....should have one.

Edit...yup, I have one. PM me.

 

[chargehard]

looking for large pinion shim that goes behind rear pinion bearing used to set pinion depth.

 

[RT/10]

The 742 does not use a solid pinion spacer or crush sleeve. A 741 uses a solid pinion spacer and a 489 case uses a crush sleeve. The 742 needs nothing due to the design of the pinion.

Do you know the thickness of the shim you need? There's several different ones. I have a few, might have what you need.

 

[chargehard]

i have one coming,once i get it set up ill know if its right or not,thank you,john.

 

[chargehard]

need a shim smaller than .092"

 

[wannadrag]

Did you try Dr Differential?

 

[daredevil]

The 742 does not use a solid pinion spacer or crush sleeve. A 741 uses a solid pinion spacer and a 489 case uses a crush sleeve. The 742 needs nothing due to the design of the pinion.

Do you know the thickness of the shim you need? There's several different ones. I have a few, might have what you need.

The 742 doesn't use a crush sleeve....but uses a spacer. I'll take a look....should have one.

Edit...yup, I have one. PM me.

Thanks for learning me.Would bet Mancini has those too.

 

[Cranky]

The 742 does not use a solid pinion spacer or crush sleeve. A 741 uses a solid pinion spacer and a 489 case uses a crush sleeve. The 742 needs nothing due to the design of the pinion.

Do you know the thickness of the shim you need? There's several different ones. I have a few, might have what you need.

Been awhile since setting up any diff....it's nuts what ya forget over time.