killercharger
New Member
could I bore my 318 .90 over and put KB Performance KB167KTM.040 360 pistons in it
can a LA 318 be bored out .90
- Thread starter killercharger
- Start date
Having it sonic checked is the only way to tell for sure.
killercharger
New Member
If I got new .40 over pistons could i reuse the old rods or do I need to get new rods.
did you mean .090?
Because .90 is almost an inch. 7/8 is .875 so .90 more than 7/8
- Local time
- 12:18 PM
- Joined
- Dec 25, 2011
- Messages
- 5,766
- Reaction score
- 7,264
- Location
- White Cloud, MI
.
- Local time
- 12:18 PM
- Joined
- Dec 25, 2011
- Messages
- 5,766
- Reaction score
- 7,264
- Location
- White Cloud, MI
Probably not the best idea. Stronger cylinder walls = better ring seal.
Mike
Mike
- Local time
- 11:18 AM
- Joined
- Sep 6, 2009
- Messages
- 1,665
- Reaction score
- 1,779
- Location
- Boulder City, NV.
As I remember a 360 has a different longer stroke length
and thus a different compression distance.
The short answer in my opinion definitely NOT!
I am currently finishing a 318/3 Truck block out of a
Bobtail truck. At 060 it was 235 on the worst thrust side
which is amazing.
No doubt my enemies will argue about this with me tomorrow!
and thus a different compression distance.
The short answer in my opinion definitely NOT!
I am currently finishing a 318/3 Truck block out of a
Bobtail truck. At 060 it was 235 on the worst thrust side
which is amazing.
No doubt my enemies will argue about this with me tomorrow!
Last edited:
Similar threads
