• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

SOLD {FOUND}: Mopar Stage VI heads Adapter Plates for 440 OR Stage VI Intake Manifold

Status
Not open for further replies.

HawkRod

Formerly hsorman
Staff member
FBBO Gold Member
Local time
5:27 AM
Joined
Aug 8, 2011
Messages
7,047
Reaction score
15,896
Location
Lansdale, PA
Feedback: 8 / 0 / 0
Contact seller
Found and purchased. This thread no longer valid.

I am building my buddy's 440 (RB) big block. We have a set of Stage VI aluminum heads. However, when used with a 440, it is my understanding that adapter plates are needed between the heads and the intake manifold - OR - a special Stage VI intake manifold is needed.

I believe the spacers look like the picture below.

1698433965048.png


The intake looks similar to the below - it is basically a wider intake than a RB intake.
1698452296808.png


I need to buy either and figured I would start and try with FBBO!

Thanks,

Hawk
 
Last edited:
Or the right mopar intake. They're still out there.
 
I have set of new Angelucci Mfg. ones in storage, I will get them out this weekend and PM you
 
Hawk put up a standard opening port gasket to the head so you you know where you're at. I went through this helping a friend out
 
Status
Not open for further replies.
Auto Transport Service
Back
Top