SOLD Front floor pan with hump & console brackets 70 71 Charger GTX Super Bee Road Runner

[Moparparts]

FOR SALE: 71 72 Road Runner, GTX, Satellite Sebring Plus, Charger, or Super Bee front 3/4 floor pan with hump and automatic console brackets for a 2 door. Could also be used for 70. This is a full front pan, except for the driver's side section. It has been taken off correctly at the factory seams and spot welds, trimmed, and is ready for final prep and installation. Very good used condition, except for a small rust area on the passenger's side at the spot weld hole area where the front rail would meet the torsion bar crossmember. There is also a small rust spot, as shown in the pic, at the top outer corner of the toe pan. This does not have the inner bucket seat support brackets on the bottom side. $300 complete, as pictured. I would consider selling the right side full floor pan section and/or hump with console brackets separately. This is too large to go by ground shipping, unless the driver's side under the seat pan would be trimmed off. Could be picked up here in PA at 17086 or possibly at one of the Carlisle events. PM or post.

 

[joshb1983]

is this for the 70 or 71 and on

 

[Moparparts]

Sorry about the mistake i need to find out how to edit it, this is for a 71-72 B-Body NOT 70 as can be seen by the console brackets

is this for the 70 or 71 and on

 

[Moparparts]

Still available, post or PM Carlisle delivery is possible

 

[Moparparts]

Will consider selling in sections also post or PM

 

[mrsnicks]

Would you be willing to PM me full size pics of those pans so I know where/how to drill out mine when it comes time to replace them? I'd be interested but am in NC and won't be going to carlisyle and the big appeal is that it is all 1 section, which is prohibitive for shipping.

Patrick

 

[Moparparts]

Patrick
The pics listed here show clearly where it needs drilled to remove it. You can also copy the pics on here save them to your computer and enlarge them some that way. The best way to tell where they will need removed is by cleaning the area on your existing pans in your car to see where the spot welds are located for drilling and removal. Also this can be easily shipped by UPS if the drivers rear pan is removed for shipping. If you would like pics of certain area to assist you in removal i can take some pics when i remove it from storage and send them to you just let me know what e-mail to send them to
Don

\

Would you be willing to PM me full size pics of those pans so I know where/how to drill out mine when it comes time to replace them? I'd be interested but am in NC and won't be going to carlisyle and the big appeal is that it is all 1 section, which is prohibitive for shipping.

Patrick

 

[Moparparts]

SOLD! Thanks FBBO