funnycar
Well-Known Member
need 2 of the sleeve nut in photo please for stock exhaust rear .1963 dodge polara.
FOUND wtb 2 exhaust sleeve nuts
- Thread starter funnycar
- Start date
- Status
what length are?
think I have a couple laying around, but they were for 1970 440+6 engine ... may work for you.
if I do you are welcome to it, just need shipping. can do flat rate box or envelope.
Bill
think I have a couple laying around, but they were for 1970 440+6 engine ... may work for you.
if I do you are welcome to it, just need shipping. can do flat rate box or envelope.
Bill
funnycar
Well-Known Member
looks like 3/8 24 thread and width of exhaust manifold is 3 1/4 .
the barrel nut I have is right at 3", and there is about 1/4" of inside mounting surface in your manifold
so it will work.
see pic.
just send $6.00 to cover USPS mail.
Paypal (friend/family). [email protected]
need ur address too...
Bill
so it will work.
see pic.
just send $6.00 to cover USPS mail.
Paypal (friend/family). [email protected]
need ur address too...
Bill
funnycar
Well-Known Member
will do thank you for your help
sent a PM.
can u reply tp the PM with your full address
thanx - bill
can u reply tp the PM with your full address
thanx - bill
- Status
Similar threads
