Recent content by 1966Canuck

nice find ..... I had a 73........... i have never seen that rear side window style ? S E models had the 3 vent style and my 73 had roll down rears

you can also buy a sound bar like for TV and lay it across rear seat. put quick dis-connect wire couplers on it and then you can throw it in the trunk when not in use.

I have 6 inch round rears in my 440 ragtop that were already there.They are black grilles so they don't look like an eye sore. Stereo sounds good with the top up but shitty with the top down. If you want to get more bass and depth they make slide under seat slim sub-woofers ( about $80 and up)...

my l e d tubes have little switches on the tubes to change from bright white to warm lighting I believe

Glad I talked him into the paint protection but he refused the hood deflector

thats only 60 K Canadian lol

Hello all : i recently spoke to a Auto Wrecker that I used to get parts from 35 years ago.They are still operating but most of the old vintage cars were crushed for steel value sometime ago. they still have a couple of buildings which have lots of Moparts and mechanical stuff from the sixties...

well I got my new trans mount installed and against a lot of opinions from some of my mechanical friends the replacement has cured all my issues.Feels like a new 58 year old car! The vibration was even noticeable at a certain RPM in neutral which means it was resonating thought the crossmember...

thanks to all. My bearings were toast on their own but the tech found a broken tranny mount. I have to source one

they haven't Road tested it yet but my concern is If there is a problem with the pinion angle is it going to keep ruining pinion bearings ?

I also have a similar bad vibes........ 40 mph + on light acceleration I feel shuddering under drivers floor and felt in the steering wheel. My U-joints are good and my transmission tail shaft is fine. If I put the car in neutral at 50 mph it coasts smoothly with no vibration at all.2 days ago...

hello all; I am chasing down a vibration/resonation in my 66 Coronet (stock engine) and I am going to change out the spark plugs in case it is a misfire. Anyone have recommendations on the best spark plugs application for this old girl ? Thanks

the hole saw is an odball 3 and 3/4 not found in hole saw kits marine stainless cupholders and the hole saw avail on amazon. I used cedar for weight and Velcro on the underside of the cut hump arches that grip the factory carpet

After many beverage tip-overs i tried to find a cup holder and or cup holders for my bench seat 66 Coronet. The only options I found that looked retro we're in the $300 range so I decided to take matters into my own hands. With one piece of cedar about an inch thick i i managed to attach three...

hello all my 1966 Coronet has one of those retro stereos that was made to look like a factory radio but it finally bit the dust. It wasn't very good quality or sound to begin with so I had decided to look for an option that would fit in the glove box. this unit his Bluetooth and has many other...