Search results for query: *

Thanks for that, I think the back bracket is slightly out as I need top push the back of the plastic console over to the passenger side about 1/2 an inch to get the screws in. Hopefully it wont affect the fitting of the top plates.

Yea im thinking that too. Just wanted to see if someone else had the same issue. The front console mount looks like it was welded like that from factory. Thanks again

Thanks Dave. my brackets are already welded in and carpet is in. I put a level on the front bracket that holds the shifter just where the console sits to screw it on and it has a lean to the passenger side yet the top where the shifter mounts is straight. The rear bracket is the same it has a...

Hi there, I am fitting up my Centre console after a full floor replacement. I am wondering if the Centre console is meant to sit straight on the floor or have a slight lean to the Left? I see my bracket for the shifter plate and rear mounting plate that the console screws to has a lean to the...

Hi guys, I'm after a right hand side rear window stainless corner trim for a 69 Charger if anyone can help?

Thanks very much . Ill go with that. Cheers

Hi there. Just wondering if anyone may have come across or can tell me what size these main bearings may be. they look original but No sizing on them just 6-68 TC. I am wanting to re bearing an engine without Removing the crankshaft if possible. Thanks again

Hi there, Im looking for a passenger side, upper headlight splash shield if anyone can help. You may have an old fender lying around with one still inside it. Let me know if you can help. Posted a photo of the driver side one i do have, just needing the R/H side. Cheers

Ok thanks for that, just doesn't look right but it is what it is im guessing.. Cheers

Hi there, I have replaced the vent window seals on my 69 Charger, i noticed the gap between the lower vent window seal and the door gap it sits it. Does this need a sealant to fill in the gap or just put the stainless trim on? Just worried about water going into my doors if the rubbers not tight...

Yea mines punched from the inside out. And is in the inner wheelhouse. Strange one but im determined to find out why its there. Finding the photo i got of it pre strip showing a bolt and nut in the outer wheel well make me think its retaining something on the inside there. Cheers

Could well be. I am going to refit the seat back and see if a bolt with a washer would hold the seat in. Thanks for your help

Thanks again for your help. Cheers

I just found this photo before i stripped car down. Shows a bolt and nut but dont know what it would fasten inside. Looks like factory nut etc seat retainer??

Hi there. Its a 1969 Dodge charger. Wheel wells are original to car and have not been replaced. The car was purchased as a rolling body fro Arizona with original paint on it. Thanks again for your help

So if thats the case then a couple of rubber plugs to seal them up?

Yea there is one on each side and they are pushed holes not like they have been drilled out

No he didnt mate. These are factory holes that go from the inside part of the wheel well . Ill put up a pic Cheers

Hi there. Can anyone tell me what the holes are for in my wheel wells just below the lower hooks for the rear seat. Thanks again

Looking for some myself or the next best thing to use