Search results for query: *

Bench seat from my 63 Plymouth Savoy. Black vinyl done 2 years ago. Very little use as it took a long time to finish the car. Reason for selling is that my rollbar doesn't allow me to move the seat back far enough to be comfortable using the brake pedal. Little room between the seat and...

Hughes Engines has an article on rear main seal installation. Search rear main seals and find instructions for it. Good article.

Here is an led bulb story. We had an older Pontiac Firebird in the shop for no cruise control. The tech kept checking electronic stuff on the car. Customer agrees to replace the ECM, no change. I am not sure what they all replaced on the car, but the end result was the previous owner put in led...

Cars that I know which they have done this, 64 Ply SS/FA, 63 Dodge B/SA, 71 Demon D/SA, and a 71 Demon E/SA.

Just something you may want to do. I did this on my 63. Most mopar guys I know do it. Install a brake pedal stop so the pedal can only come back as far as needed. Some racers have had the rod drop out of the master cylinder because under hard acceleration the pedal on some will come back alowing...

On my 63 the top left door hinge works fine and the door fits well. I have the hinge spring ( if that's what it's called), but the small roller that goes on it is gone. Would be nice to keep the door open to get in and out. Can this be repaired without taking the hinge off? Or is it necessary to...

I know Mopar doesn't make them anymore, but what part number would be on the seal or box if NOS? I have seen two part numbers mentioned. Not sure where to look this up. Thanks.

Also Pat O'Brian in Chicago says give Mike from High Flow Cylinder Heads a call at 708-396-0505. Tell him Pat O'Brian said to give him a call.

In the Minneapolis MN area it's [email protected]. Longtime Mopar cylinder head guy. Did my 63 Max Wedge heads. Doesn't cost anything to ask. Good luck in your search. I also have a friend in Chicago that I will ask who he knows.

I need to clean up the head, but I think it's a 2406516 383 head.

Anyone know of 2406518 cylinder heads with a heat crossover? What were they used on? 426 Street wedge? Thanks for any info.

I went with the K & P billet aluminum filter.

Nice job on the tunnel. My friends 63 is a classic race car he runs in nostalgia. He doesn't want to cut the tunnel. His preference.

Interested PM sent.

Posting for a friend. Looking for a CSR 836 big block shield. My friend has a 63 Ply that his buddy drives as he has lost his eyesight. Longtime Mopar guy. He is concerned about safety, but CSR is not supplying any new shields right now. So looking for a used one. Told him I would keep looking...

Original glove box from my 63 Plymouth. No holes or rips in it. $10 plus freight.

Wiper motor from my 63 Plymouth. Took this out many years ago as not needed. I also have the wiper motor switch. It worked when I took it out, I think it's a two speed, but can't recall right now. $40 plus freight.

Grill for 63 Plymouth. No damage, just needs a good cleaning. $60 plus freight.

Not sure what the L8 is for. My 3447's are with the car in storage so can't look at mine. 63 Ply and Dodge Max Wedge's used the 3447. I know the 1404's have the large opening tops like the 3705's on the 64's. Some are putting the tops from 1404's on the 3447's to get more air flow. The 3447's...

I noticed that and I know mine have the two slotted holes. Good sign for me.