Search results for query: *
- Users: 69Bee
- In Brakes, Steering & Suspension
- Order by date
-
It's Back Again!!! Have a Happy Thanksgiving...
Happy Thanksgiving to all and their families... :usflag:- 69Bee
- Post #8
- Forum: General Discussion
-
-
-
-
Summit Racing brand Gas Ported Piston Rings?
You could inquire about the manufacturer. They could be Total Seal boxed for Summit Racing. I get parts from NPW, formerly EPWi, and their white box rings are hastings rings at a substantial price reduction.- 69Bee
- Post #4
- Forum: Engine, Trans & Driveline
-
-
-
-
Happy Birthday Big Bill
Happy Birthday... :bday: :bday: :bday: :bday:- 69Bee
- Post #7
- Forum: General Discussion
-
Flameless wrist pin install
I use a cutting torch secured in a vise so that I can heat the rod pin end. I takes me about 20 minutes to set out the pistons, identify the front, ID the rod number and front, lube the pins and pistons, then heat and install 8 pistons to rods. The torch is below the overhead propane shop...- 69Bee
- Post #3
- Forum: Engine, Trans & Driveline
-
-
Happy Birthday to Turboomni
Happy Birthday... :bday: :bday: :bday: :bday:- 69Bee
- Post #22
- Forum: General Discussion
-
-
-
New 360 build with oil leaking into coolant
I always vacuum check "New" heads to check valve seal and usually find at least one valve I have to cut the seat and grind the valve for it to seal. When they build the complete heads, they take the bare heads, populate the valves, install seals and springs, and stuff it into a bag and box...- 69Bee
- Post #46
- Forum: Engine, Trans & Driveline
-
New 360 build with oil leaking into coolant
You are chasing your tail and the "Symptoms" caused by the problem. You keep talking about the pass side head does not compress the head gasket, and THAT is your problem causing to symptoms that you are chasing. Remove the head gasket and put the head on the block. If the head cannot go all...- 69Bee
- Post #43
- Forum: Engine, Trans & Driveline
-
New 360 build with oil leaking into coolant
This is my take. First, on each side of the block deck, there is a passage from the cam to pass oil to the head rocker oiling passage. On either side of these oil holes, are coolant holes. My choice is oil going into one or both water holes, thus your transition point, but why? You already...- 69Bee
- Post #35
- Forum: Engine, Trans & Driveline
-
deep frying a turkey........ any tips?
My wife's family cooked theirs this way and I found it to taste good; I prefer the crunchy skin anyway. Be very careful, hot oil and all, and I think the turkey needs to be thawed out. Frozen turkey will have moisture that can cause problems. Another plus is that it only takes a few minutes...- 69Bee
- Post #3
- Forum: General Discussion
-
-
-
-
First and Best Ghost Riders in the Sky...
Saw Molly Hatchet & The Outlaws in Germany back in the early 80's...- 69Bee
- Post #3
- Forum: General Discussion
-
Happy Birthday Dennis H
Happy Birthday... :bday: :bday: :bday: :bday:- 69Bee
- Post #23
- Forum: General Discussion
-
-