Search results for query: *

Installation manual I had handy Yukon Gear Manual: Break-In: All new gear sets require a break in period to prevent damage from overheating. After driving the first 15 mile or 20 miles it is best to let the differential cool before proceeding. I recommend at least 500 miles before towing. I...

What happened to the system to need a new compressor? If it had a compressor failure? Also don't trust it saying had oil in it. I have seen a compressor come with almost nothing in it yet it claimed was ready to go. Was even warned by an a/c shop to check them also. Did you flush the system out...

Thanks guys for the info. DERV and peabodyracin you guys were correct. There was a tape covering the slots on the trunk lid. Once I pulled it back there was slots and the nuts were exposed for me to get to. Was so worried about breaking them because figured not like you would go down to local...

Any way to safely remove them so I can reuse them again? Want to paint the car but worried if I take them off I either will break them or not be able to put them back in with whatever retainer is holding them now. I do have panel popping tools and think I can just get under them and pop them...

Seemed to be fine for me. Pulled hard from idle to full throttle. Instant acceleration with no bogging when I went from idle to floor. Were you running manual or vacuum actuated on the outboard carbs?

Old pics from early days. Not a whole lot has changed since these were taken. Except for adding the blower and removing rest of headliner. Just got done this weekend redoing the electric fan mount setup.

Originally I had a six pak setup on it. Took it off when I went to the blower. Car is partially caged. Still need to finish that. Dana 60 rear that has been narrowed with Dutchman race axles. Rear end is pulled forward 1 1/2 inches. Engine is 440 with a 8-71 blower on it. The engine is pulled 5...

Here is mine. Not pretty but goes good. Still working on it.