Search results for query: *

Mopar switches tipically gets: 1 positive from Batt/Charging circuit to feed headlights (Black wire, 12 gauge) 1 positive from fuse box batt side buss to feed parkings and cluster dimmer (pink as far I recall) Then sources these outputs at least up to 68 (69/70 the same switch but with a...

Welcome from the greater Spartanburg, SC area. Good luck with your project. You'll find lots of good information here and folks that have seen most everything. That's been my experience at least - recommend mastering the search function :)

Correct, hence why they are white.

This guy did.

How much gain did you personally see?

Looking for an Indy Hemi tunnel ram in good shape - either 4150 or 4500 tops are fine, 16 bolt heads. PM me with what you have. Thanx FBBO !

The UP arrow is only visible when I use my phone. The function of it is to quickly scroll the page back to the top.

I agree with that, I just found the part about a 9 inch growth in length to be like an exaggeration like those add three inches ads in men's magazines.

That's part of the reason why they re-fuel the Blackbird after take-off.....as it leaks so much fuel until reaching a decent airspeed.

No. It's pure science....speed generates heat, and heat makes metal expand. :)

Come on, man...It just seemed impossible. I thought you might have been exaggerating to see who was paying attention.

So much for the topic title.....not having to Fact Check. :rolleyes:

Up to nine inches in total length - haps opened up all over the aircraft - it only takes a small amount along the entire length to add up fast. Some of those articles printed these days are AI generated from tosh that other people have written while being mis-informed. I have been on-board two...

There is an assumption that I do not know anything about rods and crankshafts? I have worked in a specialist V8 machine shop for 25 years! I can bore blocks, deck blocks, regrind crankshafts and balance them as well. Rod prep has been my go to subject for 25 years. All I asked for was thoughts...

Hello PsyOps, At last in 2025 a sensible question. Factory slugs are cast six-pack pistons. The new replacements are Indian Speed Pro, forged. How good they are is yet to be discovered? They are no heavier than the factory High compression cast piston. I could lighten them but reciprocating...

$680 for labor? Why would you pay that instead of doing it yourself? 37 lbs? Stock is 34.

Nine inches?? I had to look this up. It seemed impossible! The article states 30 mm which is what? 1 3/16". Is that in diameter or in length?