Search results for query: *

how would he seal off the fuel leak from the hole for elastomer valve

Hey every one im sure this topic has be gone over a few times, im going to be replacing the stock intake with a performer rpm and was going to order the felpro Performance 1215 Intake Manifold Set just wondering if i use all four intake to head gaskets with the valley pan sandwiched in between...

Sent PM

Thanks this helps!

Thank you!

Not really sure what the OP is trying to accomplish. There is no amount of milling of the deck surface of 915 head to get a heart shaped combustion chamber. To the OP, do you think there is something to be gained from eliminating the relatively sharp transition from the machined surface to the...

Hi Folks, Does anyone offer a replacement lower steering column bearing for 1968-69 cars with automatic on the column shift ? All I am seeing form Classic Industries and others indicate the only one available is for a manual trans or auto floor shift car. Any ideas ? Thanks in advance, Rob

Chicago Carburetor - Or the cheap way is to use any front v-bowl and block the accelerator pump hole with JB Weld epoxy

I think you meant nuances .....but I catch your drift. :thumbsup: Book are excellent reference material that will last a lifetime...as long as they are authored by knowledgeable people, and not the average shade-tree wannabe. One of the most common replies people asking technical...

Hey All, Finally found the right car after a long search and trying to figure out which shipping service is best. I used a broker once and it was alright, but with a bit of communication problems. Figured I’d reach out and see what everyone recommends. Thank you in advance! Kyle

I have the story now. I have a 73 and up gear box. Some where along the way, someone got a steering box of a later origin . They in turn transferred the fitting to the 73 and later to steering box. I talked to the man that I bought it from on eBay, he said that I had the 73 box and that he had...

I had hoped the KB162 was similar to the originals, as the manufacturer advertised. But they aren't. However, I do have these lower compression pistons in another 69 383,9(Possibly,2008) and it runs very well. not the quickest, but after 20 years it still runs great. I can say an original 383...

Can you be specific and give more details on the '69 Super Bee... such as condition of the body: Is there any rust issues on any or all panels? Is the undercarriage free of any major rust? Are the floor pans and trunk pans in good condition? Does it run/ drive safely currently? Is it the...

IMO, 295/55/15 is the sweet spot. They are the same height as the 275/60/15 and fit on an 8" rim. I am running the 295/55/15 in the rear and 225/70/15 up front.

My eyes!!!

Yes, on 8" steelies.

Once again, the truth floated on. Healthy wiring and believe it or not a powerful alt (anything better than the stock) able to keep feeding the car without constantly request power from batt will save the installation. Aside newer acc added long the years, correctly added to the alt side and...

Lousy pictures, these are pictures of the original intake off my 66 hemi with original paint. Bought orange paint to see how it matched.

yah yah a can in a can ,then stop that hound dog from droolin in it!

summit, holley 2300 carb? 0- 4670 bowl fit that? if they sell the carb they must have bowls