Search results for query: *

There are many ways to skin a rabbit.. 71 Satellites have less clearance between the bumper and the hydraulic lift cylinder. Rather than scuff the bumper or risk denting it. Lifting the *** of the car was easiest for me. And in KD's last image the angle I pulled it was less severe than the angle...

hello, reading this post, Fuel tank configuration (lines) My Charger do not have this black vapor separator close to the pump, there is a corked return line to the tank .. do you think that issue could come from this? Thanks

Thanks. Good idea. Yeah I have a similar DECAL WORKS plastic applicator. I haven’t tried yet but believe will have to soften the paint before scraping off.

In the course of my searching I discovered that hers is not the only death in jr dragster. There was a case of a girl in Australia who died on her first pass, and at least one other I found. Like I posted earlier, I didn’t think they were that dangerous. The sad thing is that kids die in...

I have this one but, it's from a 70 383 R.R.

WOW! Guys, we really need to go back to basic electricity and electronics. What does a ballast resistor do? Good question, glad you asked. It was used in the old days because points would ground out the coil for a long time at idle, and less time as RPMs increased. Now for the reflection on...

Me first!

Looking for 1963 4 door fury parts

After growing up with both parents smoking cigs and cigars, I never wanted to try it and am glad I didn't. Can't stand the smell of cigs, cigars, vape, weed or someone who does.

Looking at ZDDP (zinc) oils and additives, understand that the zinc must be in a colloidal form. Basically, this is a molecule. A molecule will easily flow through any oil filter out there -- Fram, Wix, Amsoil, all of them. There may be an issue where you are using a SN rated oil, which is...

For a short time, I dated a girl who was a moderate smoker. She had big boobs and I can remember they even had the taste of cigarette smoke on them. It’s like the smoke had saturated her whole body and it oozed through her skin.

I know i can buy new, but checking to see if anyone has a set for rear wheel well 1970 coronet. email is fastest for response. [email protected] Thanks

It will. Because realigning the hood afterwards can be annoying. Not always but in cars with shorter hoods, maybe so. Says who? Have you actually tried it? Sometimes a man does not have a helper handy to remove a hood. In the case of this Charger, it wasn't necessary. There was...

Parked uphill, turn wheels to the right against the curb. (forces right rear tire into the curb on a roll) Parked downhill, turn wheels to the right against the curb. (forces right front tire against the curb on a roll). Drivers' ED 101.

Of course, with a lift off hood the question is somewhat moot, regardless of the removeable center section of my radiator core support. to assist engine swaps.

Not sure if this allowed. Below are the steps required to set up a gofundme page. Sounds like emotions are running a little high. Relax and concentrate on care for your mom. I sincerely hope this helps. This info was copied from AI. I take no credit for it's content. God Bless "To set up a...

I say go for it even if it’s near impossible, you could get it right, I doubt the drill bits are a fortune so why not try?

I just sold a 67 Hemi Coronet. Have 67 Hemi Charger and 66 Hemi Satellite left.