Search results for query: *

I think you will have a different opinion once the rubber seal is in place.

Once the gasket is installed on the glass and the windshield is roped in, everything will look right. My question is why is all this trim installed before the windshield?

I was tempted to cut the whole corner off but that left way too much room for error! The first patch is awesome. I did it from the back side this time. I’ll probably do the rest like this. Easier to finish clean.

First off, all of the pictures need more grease on the pivot points, that will reduce effort. Over the center spring helps you push pedal at higher rpm with original B&B which has rollers/weights to apply more pressure at higher rpm/power levels. It will hold pedal on the floor with a diaphragm...

I would call them if the filter housing is indeed marked wrong.

Welcome, your lucky to have a car with a family history. Tell us more.

:rofl: :rofl:

Then the filter housing was incorrectly marked or casted wrong. Because the input has to enter on the outer part of the filter and the output has to be on the center port of the filter. With the filter and lines removed you can observe the port entries. The picture I posted shows the housing...

Welcome. Great looking Coronet.

When I am done with it. :poke:

G'day from Australia :welcome:

G'day from Australia :welcome:

We are getting ready to install the windshield in this 1967 Plymouth GTX convertible and wanted to verify I am not missing something here. The fit between the dash and the window pillar and the stainless trim seems excessive. Is this normal? And wondering if there is something that covers the...

69bfan added a new event: Holley Moparty, Bowling Green, KY. September 12-14, 2025 Read more about this event...

Once again, we have stepped up to be one of the event sponsors for the Moparty in Bowling Green, KY. The show this year is scheduled for September 12th through 14th. For those who have never attended, this is a relatively new event that offers a very diverse coverage of show cars, drag racing...

Great job. You beat me to it! Im working on one for my 68. Just got my 3rd printer hooked up. I love how the use of 3d printed parts is becoming more popular

Just to close this out because it was bothering me, I went and very carefully (minus any blinders) looked at the ports and plumbing. In order for this to work the the plumbing MUST be as follows; The top (OUT) port of the engine to the OUT port on the filter housing The bottom (IN) port of the...

Welcome from Alabama, great day 2 hotrod.