Search results for query: *

If stock spindles from a 65 B body with drum brakes will work? I have a set .... blasted and painted. Cheep :rolleyes:

For two to go at the same time it is not a coincidence. The same reason would have caused both failures. I wonder if the cams lobes had a little bit of taper ground on them causing the lifter to try and rotate and overloading the tie bars? There should be no real rotating force that the tie bar...

Cool collection ! My neck hurts :rolleyes:

Make one hell of a Hookah!

Maybe get the oil pan from 440 source? They have one made out of thicker steel.

he does pretty good with no thumbs

There was a whole lot of diecast NHRA rails and funny cars which I didn't know much about so I just picked the Matco one. Seemed fancy. I might list them for sale.

Hard to explain as mine is already installed and I can’t take a pic. I had to look a few times by holding a clip up where the trim runs along the roof.

Nice job oc and Bud! :thumbsup:

welcome to FBBO from Pa

I have a 1967 Dodge Coronet R/T, 440 Magnum, that I converted to electronic ignition last spring. I purchased the distributor, coil, ignition control module, and ballast resistor as a kit through Summit Racing. The car ran great for most of the year, in the fall I blew a voltage regulator. So...

You need to get a "Little Giant"!!

I dont get where “ they fit into”

Welcome from Connecticut.

I think they both went within 10 minutes of each other. Went I first heard the noise I thought it was a header gasket. Not going to lie. Then about 3 minutes later when I got in to town it backfired and I think that’s when the second one went. I was only a couple minutes from home at the time.

Welcome - nice Belvie!

Bump...

Thanks for the response, koosh. JEGS states "Fits select" cars but does not state what "select" means. Also says "See Fitment Tab for all applications" but they have that tab pretty well hidden. I can't find it. I'm really confused about this subject since there are all kinds of speedo...

After you buy it, we'll all think of things for you to do with it.