Search results for query: *

Welcome aboard, looks like it has good bones.

Do you have Pictures of a complete 64 Dodge B Body Jack? These pictures helping me very good.

And this is a quote from another thread where I posted the brush holder diff for the squareback alt versions. While brushes interchanges, the top holder doesn’t

That is not actually dated correct for 74 but roundback for 70/71 having both provisions available (single and dual field). Probably replacement for those. The correct date alt will look like this: Which from back looks pretty much similar to the revised version used by Powermaster and Mopar...

I love the smell of gasoline. I REALLY love the smell of leaded gasoline. I have old cars out back, they all have at least a little bit of the raw fuel smell and I absolutely love it. Nothing compares to the memories that go through my head when I am in or near a classic car. The interiors of...

R.I.P.

Welcome, and good luck with your project....it'll be a great car. Go ahead and ask away! Oh, and you get extra points for including pictures on your first post. :)

Welcome, dandelion. It'll be hard to identify a lot of modifications to your engine, aside from obvious bolt ons, without opening it up to measure things. What sort of drag car is the engine in? We like pictures here. :)

Look around the gas tank seams for leakage...

I presume this carb has 4 idle mixture screws? If so, opening the secs is just transferring the problem to the secs.......will still be rich because extra fuel coming from the now exposed sec T slot. Correct fix is more idle air. Some of these carbs had an adjustable air screw. If not, the...

What heat range?

It could be the alt is on the threshold of charging, ie the alt output voltage needs to be higher than the bat voltage; alt voltage could be changing/varying slightly at this changeover point, which could explain why the problem goes away with more rpm which will increase alt output. If this is...

I thought the 1310 was a Chebby size [ 1 1/16" ] & Chrys used 1 3/32".

I see the prods are not parallel, intake is offset. That is probably putting some side force on the link bar. There is not much metal above & below the slot in the link bar, & that is where the failure occurred. Could the failure have been caused by flexing due to the prod being at an angle?

Thread revival - I just bought the Spectra one also and it is a very tight fit with the oil fill hole in my cast aluminum Mopar valve covers. I thought you meant it seals tight, but it is actually difficult to insert into the hole before twisting tight. At first I thought it didn't fit at all...

What I can tell you. I had a 1961 Dodge Phoenix. My friend had a 1962 Dodge Phoenix, first year of the 'unibody'. Both were 4 door pillared cars. We both had 440s with alum TFs. We weighed our cars same day, one after the other. My 61 was 400 lb heavier.

I’m behind you hopefully not 24 years!! But will be close. But it’s fun! Right??

Welcome to FBBO!

Hi everyone, I recently acquired a drag car with a mystery 440 in it. The car had "10.90" in grease paint still on the window when I bought it, so I'm guessing the motor is pretty hot! All I really know is that it previously ran on Sunoco 110 fuel, and that it may have been bored out to a...