Search results for query: *

I am looking for a nice passenger side lower control arm with the sway bar tab for a 68 b-body. I would buy a pair if necessary. Thanks! [email protected]

I make the rear tie-down brackets that bolt on to the existing u-bolts, you just need to have enough extra thread hanging down to fit my bracket and another nut. They are $70 including shipping anywhere in the United States. Feel free to email me with any questions [email protected]

70 Coronet R/T or Coronet 500 finish panel. This is in fair condition, it will need some work. There is damage around the hole for the truck lock, as well as some damage in a couple areas on the outer edge. All the DODGE letters are there, as well as the R/T emblem. No shipping. I can deliver it...

NOS 1973-74 drivers side big block HP exhaust manifold for a 400 or 440 B-body. The casting number is 3751068 with a 2-20-73 casting date. This manifold is brand new, it has never been bolted to an engine. $300 obo. No shipping, pickup in central CT, or I can deliver it to Chryslers at Carlisle.

Passenger side fender from a 1970 Dodge Coronet. Has a little rust through at the bottom and also a little damage from someone using a torch to cut off the front valance bolts. These are hard to find and are not reproduced. Can also be used to make a Plymouth Superbird fender. No shipping. I can...

Trunk lid for a 1967 Coronet. It is in better condition than most out there. A little pitting on the rear inner lip, but no rust through at all, still has its original paint. No shipping. I can deliver it to Chrysler's at Carlisle or you can pick it up in central Connecticut $450 obo

Do you have the rear brakes adjusted properly? If they are excessively loose it would cause the problem you are describing.

The center to center measurement front to back is 3.550", the center to center measurement from side to side is 3.050"

Yes, they will fit between the shock plate and the leaf spring. The access to the hole for the tie-down strap hook is not as easy to access when installed that way. I also have a set that will fit cars with Caltracs.

Laser cut rear trailer tie down brackets for most A, B, or E body vehicles (doesn’t fit the 7 ¼ rear axle). These piggyback onto the bottom of the stock shock plate mounting nuts and then 4 more nuts hold these tie down brackets on. You must have enough extra thread hanging down on the bottom of...