Search results for query: *

Thank You. Much appreciated.

Looking to put dodge rallye wheels on my 1968 coronet r/t convertible. Can anyone help with the original equipment spec's / size of these wheels. Currently the car has 15" cragers. I believe that Original equipment was 14". Thanks for helping.

Looking for a pair of drip rails for my 71 charger SE. Must be close to show quality.

Purchased a 71 Charger and it didn't have either of the wiper arms installed. I was able to purchase a set but struggling to get them installed. There appears to be a black plastic grooved tip on each side. Assuming this stays on and does not get removed. The driver side has two arms that...

positive wire at the starter relay was loose. tightened it up and all seems good. Thanks for all the help!!

Thanks 5wndwcpe. Product seems just what I'm looking for. Ordered some samples to color match. I appreciate your help. Jomidabr.

Anyone have any ideas on where I can purchase a good quality boot cover for my 68 Coronet RT convertible.

Put the new seal in yesterday. Went in pretty easily. Tried without any RTV first, no leaks so far. Thanks to all who helped with this post. I appreciate it.

When I turn the key to start, some times is does nothing.. no clicking, no turn. Other times, it starts right up. Sometimes, if I hold the key in the start position for a few seconds, it will then turnover. I'm going to replace the ignition switch to see if that takes care of it. Any ideas...

Awesome, thank you very much.

Thanks 71charger_fan ...where did you find the "improved design"??

Thanks Bb70charger500. You were right $8 bucks

Thanks WileERobby. Not sure what the sock is....

Thanks PurpleBeeper. I purchased a new seal today and will give it a try.

Just had a new fuel tank put on my Charger and it is leaking when I fill it more than the height of the filler neck right were the neck meets the tank. There is a rather larger black rubber washer around the neck at this location. Any ideas what on what could be causing the leak, given that...

Just purchased a 71 Charger and the passenger side AC vent piece was loose. Went to see if I could "snap" it in, and it came completly out. Anyone have any ideas on best way to secure?fasten this piece. It is about 20" wide, has an AC vent on each side and Charger label in the middle. Thanks...

Temp stayed about the same at @ 190. Coolant is now about 1.5 inches below the top. Also, tried a new cap tonight. Take er out in the morning and see. based on yours and other responses, I think I might of just had too much coolant in it.

Motor is running absolutely perfect and strong. Temperature is steady at around 190-200 degrees. drove about 40 miles last night and stopped for gas afterwards and the antifreeze was pouring out of the overflow tube. Any suggestions on steps to diagnose the problem?? I appreciate the help...

:hatwave:Fortunate to have the mecum auction in my backyard every year here in the Chicago area. Always enjoy seeing the variety of vehicles. Will be making the trip to Florida for this auction. Can't help but have a blast, especially to get out of the -35 wind chills here in Chicago. If you...

:hatwave:Welcome Aboard!!