Search results for query: *

Yep, it looks like the direction I will need to go. by the way nice looking 71 rr. mine is in violent too but came with a vinyl top.

Not in the drain pan unfortunately. For sure on the **** happening. I just hate when it's my own fault for being stupid and not paying more attention.

Thanks, I'll give it a try. I will just need to make sure the housing is in place before I put the ball and spring and retaining bolt back in.

i need ideas how to get the reverse detent check ball out of my A833 without pulling the trans if possible. It was a total bone head move on my part! I tried draining the fluid, small magnets, and blowing through the reverse detent access with compressed air. No luck! Ideas?

I have done a fair amount more searching and think I will try redline MT90 75w90 for manual transmissions. Jay Leno recommended on his website so if there is a problem I will sue him...kidding of course.

Hey guys I'm trying to find the best manual transmission fluid to run in my A833 4 speed trans. On a 71 RR, 383. When I drained the fluid it looked like atf was being used. thanks

Great, thanks for the info i appreciate the info, some of the manuals I had referenced were not very clear. - - - Updated - - - Thanks, glad to be hear. I love the early 60's mopar too. I learned to drive on a 64 Fury push button tranny.

Hi, I have a 71 roadrunner that I have rebuilt the suspension on but have heard that the suspension should be under load when torquing the bolt/nuts to spec? Is this correct and if so for all components or just specific ones? I'm specifically concerned with ball joints, tie rods, center link...