Search results for query: *

They are the best as far as I'm concerned BPE TorqueFlite Kickdown Cable Kit - Bouchillon Performance Engineering Read to notes and order wat u need additionally

I would totally recommend bouchillon performance kickdown kit for a 727 mate

Fast idle screw mate , If you open the throttle fully there's a screw underneath it , back it out and test her

Make sure the fast idle is not engaged mate , blip the throttle after a minute or 2

Check these in the below order mate Any Fault codes AFR readings/ sensor IAC steps Ignition coil / box Fuel pump / fuel pressure

I would pull the distributor and wires and redo them from scratch mate

UPDATE- Played around with the adjustment and now it shifts fine Thanks

No unless un close to fully stopped

UPDATE: I adjusted the bracket now 1-2 seconds shifts good but 2- 3 only shifts if a slight take my leg off the throttle? any pointers?

If u see my above post with pictures it seems that might be the reason cause if I go WOT it shifts bang on ? And the article is about when using an aftermarket cable

Yes it is , it's the lever that came with the bouchillon kit . I've adjusted The lever at idle to be fully forward But in the same article mentioned above it says it needs to be like this at idle ?

hey guys, im trying to adjust the kickdown on my 727 - these are the issues im facing- 1)shifts to second too fast - at like 1200 rpms ( 8-10mph ) - to 3rd at 2k rpms (15 -20 mph) 2) does not downshift to 2-1 at low speeds unless i come to a complete stop . ive got a bouchillon kickdown cable...

hey guys, im trying to adjust the kickdown on my 727 - these are the issues im facing- 1)shifts to second too fast - at like 1200 rpms ( 8-10mph ) - to 3rd at 2k rpms (15 -20 mph) 2) does not downshift to 2-1 at low speeds unless i come to a complete stop . ive got a bouchillon kickdown cable...

Do I need a new housing? Can I just keep my 741 ?

One of the best daily driver carbs I've used , if its a stock 400 then a 650 would do

If I pull the rear I'm changing the whole lot , gears , bearings etc anything else it might hurt driving her ?

if i pull the rear ill redo the whole thing , any harm in driving her like this till i pull the rear ?

flowmaster , with the windows up and AC on i can hear the whine inside the car only during acceleration going straight if i let off the throttle sounds goes away , no sound while turning

Hey lads , I'm getting a whining sound mainly under acceleration 30-40)mph. It ain't real bad but yea I can hear it over the exhaust... she just recently started doing this ..pull the diff or try changing oil first?