FOR SALE 1968 Plymouth Belvedere 4 door parting out

['68 Charger]

Hello, just got this in. 1968 Plymouth Belvedere 4 door. No engine, original from the factory SB 273 with manual trans. Trans is present but I will know more once I remove it. 4 speed pedals are in place. The guy was switching to an auto and the original steering column has been replaced with an auto on the column. 8-3/4 rear end, my guess is 2.76 open.

Clean Nevada sheet metal, fenders, hood, trunk lid, front valance, floor boards, trunk floor. Doors are in good shape with the exception of the front pass. side having a small rot hole at the lower corner that meets the door jamb. Front & rear bumpers and brackets.

Front manual drum brake set-up. No front windshield. No grille.

Like I said, just got this in, I will keep updates as I go through the parting out process.

Parts are located in Las Vegas, NV.

I can provide pics upon requests. Thanks

 

[mmissile]

Got the VIN tag and title? One-Adam-twelve.

 

[directconnection]

im interested in the front fenders and trunk lid
let me know where you are located
thanks Jim

 

['68 Charger]

Got the VIN tag and title? One-Adam-twelve.

No title yet. It was a lien sale from a tow yard. Paper work in progress. VIN tag intact on the dash frame. Dash frame in the trunk in the above pics.

Thanks

 

['68 Charger]

im interested in the front fenders and trunk lid
let me know where you are located
thanks Jim

Front fenders are sale pending. Trunk lid still available. I'm located in Las Vegas, NV.

I see that you're in San Francisco, CA and if you're going to the Fall Fling I could bring the trunk lid there to save you on shipping cost.

Thanks

 

[directconnection]

What about the pdeals?
How much for the trunk lid?
Let me know if the fenders do not sell
Thanks jim

 

[mmissile]

I was wondering how much the whole car was?..but if the fenders and decklid are gone...oh well.

 

[MJF_]

Rocker moldings?

 

['68 Charger]

Sorry folks for the delay activity on my post. I had a really busy weekend and overflowing into this week.

- directconnection (Jim) PM sent
- mmissile sorry about not selling the whole car as some of the major parts are already committed
- MJF_ sorry no rocker moldings were on the car when I got it, just the clips

 

[Kevin H]

'68,
Your inbox is full so I'll post here. How far are you parting the Coronets out? Looking for drivers from frame rail. Drop me a line.