64 330 next questions K member needed

[2059]

OK, here is are the next questions. 1) will the hood and d-lid from a 64 belvedere fit a 330 post? I know the doors and the roof line are different along with the rear quarters. 2) I need a 64/65 BB (hemi) K-Member to replace the /6 k member. I read a thread here regarding some for sale but they were dated 2010, probably gone by now. 3) What about the torsion bars. Buy new?
Thanks...

 

[5.7 hemi]

1. dont know
2. If using a b/rb or small block, the k member is the same, /6 k and hemi k are engine specific.
3.Torsion bar depend on what your plans are for the car, drag, use /6, cruise, use factory, corner carver, use aftermarket, and this also has alot to do with engine size.

 

[65hemihead]

You can use a V8 k-frame then just use the Schumacher mounts.Way cheaper then trying to find a Hemi k-frame.

 

[super-bee_ski]

Yes,
You can use a V8 K-member BUT it needs to be of that era. Not a newer K-member. If you use a later model (I think after 67) it sits the engine too far back (or too far forward, I cant remeber)
Call Schumacher for the mount conversion kit. His are the best and are a great fit. Great customer service too.
Yup, that is Mr. Dale Reed with my Max Wedge.

"Super-bee_ski"

 

[64Belvedere]

The hoods and trunklids are different. The trunk lids are completely different and the hoods have different ridges but may physically bolt on. Just won't look right.

 

[2059]

Thanks for all the leads and education. I'll start the search for the Hemi k-member and probably go with fiberglass hood and deck. The way it looks i'll use factory Torsion bars...

 

[moparmarkk]

hi,i have a big block k member from a 65 ply.i put a 70 e-body one in my car.pm me if you want it,it is a big block one,mark

 

[Endangered Species]

65 HemiHead is right. You can use the K member you have and either get aftermarket mounts or just use elephant ears.
If you go with 67 and later Hemi K member it will set your engine back 1". It's not a bad thing other than if you plan on running a Mopar Performace Crossram. The back of the passenger side of the intake will hit the fire wall.

The 6 Cyl K member is lighter so if it were mine that's the K Member I would go with.

 

[2059]

hi,i have a big block k member from a 65 ply.i put a 70 e-body one in my car.pm me if you want it,it is a big block one,mark

Thanks I'll let you know. I have a call in to ShakerHood.com to check availability. They are a little salty, at least from those guys.