WTB '67 charger rear beltline/pinchweld moulding fasteners

[charger10]

wtb fasteners for rear beltline / pinchweld moulding fasteners for '67 charger.
only need the 2 front sawhorse shaped smaller ones for each side, but would but whole set if needed.

 

[RedBeard]

Megaparts
Quarter Panel Top Trim Clip Set 1966-67 Charger, Molding Clip Sets, 132-QPTC159B Reproduction, NOS and Used Mopar Muscle Car Parts

 

[charger10]

thank you, bruce

 

[RedBeard]

thank you, bruce

The ones in the short sections behind the door take the same ones but are "shorter". Those slide inside the channel. I had to cut these down to make them work.

 

[67charger383]

I made mine out of sheet metal

 

[RedBeard]

I made mine out of sheet metal

Interesting. Any pictures?

 

[charger10]

was the sheet metal springie enough to hold . the orignals are out of spring metal.

 

[RedBeard]

was the sheet metal springie enough to hold . the orignals are out of spring metal.

I would stick with originals if possible. Otherwise, the reproduction ones work well.