68 coronet switches connections

[Jasoncoronet]

Ok this must exist somewhere. I am looking for a diagram that shows what the pin connections on the back of each switch do. If anybody has any diagrams that are easy to read please post them.

I have these switches:
Washer
Flasher
Dimmer
Wiper 3 speed
Lights
Foot control high beam

I have universal harness just trying to get it all setup right.

 

[67 coronet]

http://www.mymopar.com/index.php?pid=27take a look at these,should be able to figure it out from them.

 

[Jasoncoronet]

Hey thanks for the info. I have seen that before and could not find it again for some reason. This will help a little. Here is my problem is that I am using a after market wiring harness Kwikwire to be exact. I need to identify what the pins on the switches do, there function. The color codes in my kit dont match anymore. This is kind of tricky I think any advice will be well used and appreciated.

Thanks,

Jason

 

[67 coronet]

the diagram shows the connectors and where the original wires went.you just need to make sure you connect the correct pin to the correct pin.if you look at the diagram the plugs are layed out correctly.top is top,and left to right.some even show the alignment grooves in comparison to the wire points.just go slow and tripple check every hookup.i wire all my cars from scratch using just those diagrams,so it shouldnt be to tough with an aftermarket harness.