• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

69 RR BU lamp and Gas Sender wire routing

GearAddict

Well-Known Member
Local time
9:55 PM
Joined
May 13, 2012
Messages
756
Reaction score
170
Location
Tampa, FL
I'm rewiring my car front to back. The following 2 items were not hooked up at all.

Can someone describe for me how the wires should be routed for the Reverse Switch on the Tranny (through the firewall?) and same for the fuel tank sender?

Thanks in advance.
 
i want to say for the reverse switch that it comes off the tranny over to the drivers inner frame rail to a hook/clip then up to the wiring harness into the fire wall.The fuel sender is pretty much the same way.It runs along inside the frame rail,then along the inside of the inner rocker panel up under the firewall and into the wiring harness thru the firewall into the inside off your car.I'm kinda going from memory here.If i was home i would run out to my garage quick and take a look for you.
 
Fuel sender wire goes up through the trunk.Should be a hole near the spare tire mount then follows the tail light harness up to the dash.
 
Thanks guys, I believe I located the hole in the trunk for the sender wire to pass through.
 
Auto Transport Service
Back
Top