Well thanks for showing the contents of the kit and instructions after... 
Are these Eccentric UCA Bushings?
- Thread starter Moparfiend
- Start date
From this thread in 2013
- Local time
- 1:30 PM
- Joined
- Oct 18, 2008
- Messages
- 3,152
- Reaction score
- 2,454
- Location
- Kindersley,Saskatchewan, Canada
I agreeWell thanks for showing the contents of the kit and instructions after...
The thread taught us something, but it wasn't about bushings.
Sorry guys. I didn’t know the “kit” was different from the original in that it uses washers. I just pulled one of two bags that contained only one bushing each. I didn’t look under the second bag containing the other bushing. At the bottom of the box were the loose washers.
When I pulled the UCA out it was tight. I wonder how adding two washers to each side will change the stack up dimensionally….
When I pulled the UCA out it was tight. I wonder how adding two washers to each side will change the stack up dimensionally….
Ok the bushing is a different dimension from the original. It is smaller/shorter to account for the additional washers. The washers add roughly an 1/8”.
Last edited:
Hey guys, I am looking to get confirmation BEFORE I press in my offset/eccentric bushings. The goal is to increase caster as much as possible. Does this look correct to you guys? Not bushing offset directions left and right.
Note the arrows depict the movement of the UCA from bushing orientation.
Note the arrows depict the movement of the UCA from bushing orientation.
Last edited:
Similar threads
