Back up light switch operating lever missing- column shift

[JonR]

My only concern with an actual bolt is whether or not the head will clear the switch housing and then would it align/adjust correctly if the head was hitting the switch vs the shaft.

Just jam two nuts on the top and remove them when done.

Got it. Good point.

 

[JonR]

I decided to punt on this for now. Maybe at a later date I could delve into it some more. For now I installed a simple surface mount SPST switch down near the left hand air vent knob so I can turn on the lights manually when I back up. Thanks for the many suggestions - I will keep them in mind.

 

[AA1 68 R/T]

Did anyone end up making one of these in a 3d print of an original?

 

[closer9]

Did anyone end up making one of these in a 3d print of an original?

I didn't. Haven't heard if anyone else did.

 

[AA1 68 R/T]

I didn't. Haven't heard if anyone else did.

I don’t have a printer but would be nice if someone would reproduce this. I think I’m going to try and use a rollpin