Bench seat removal 1969 Super Bee

[1969CoronetR/T]

I have a set of Legendary Auto interiors bench seat covers to replace my 1980's tuck and roll job on my 1969 Coronet Super Bee (manual steering and a four speed). Does the front bench seat unbolt from underneath the car? Does the back seat just pop out or is it bolted in as well?
Thanks again

 

[al383]

yes 4 studs are on the seat,the back seat on my car i push toward trunk and pull up some times the back seat can be a little difficult

 

[1969CoronetR/T]

I got the backseat driver side off but I can not get the passenger side off. I may have to bring to a shop before I kill myself.

 

[SublimeSixpack]

While pushing down hard on the front of the base of the rear bottom cushion, also push to the rear then lift. So down, back, then up. Has always worked for me.
Then remove the two bolts on the back rest cushion at the bottom, pull forward a couple inches then up should take care of that one.
Make sense?

 

[1969CoronetR/T]

I will try again after work with the suggestion.