Carb Spacers

[DanDokken]

hello ,

I have an Offy 5186 dual quad manifold
And want to confirm the carb spacers needed to mount a pair of Holley’s.

Is this what is required?

Thanks

Dan

 

[493 Mike]

Check the carb to carb clearance. The manifold would have to have been designed to mount Holleys to have enough clearance for Holley float bowls. Few were.
Mike

 

[R/T Boy 67]

If your manifold has the small square bolt pattern, then those adapters will not fit, without doing some drilling.

 

[DanDokken]

If your manifold has the small square bolt pattern, then those adapters will not fit, without doing some drilling.

I was looking at this set up
I have same manifold

 

[493 Mike]

I can only assume this is only for appearances. A good single 4 barrel manifold will make more power.
Mike

 

[DanDokken]

Making a clone of my dads car
Single 4 now but eventually two fours
It was a poly and then 383
Look at my post you can see a photo of the poly with two fours

 

[R/T Boy 67]

Trans dapt #2064 is supposed to work, but you should do your own research.