Picking this up from a friend tomorrow who doesn’t want it in his garage anymore. It runs slow, so I’m going to restore it and probably then sell it. Anyone know anything specific about it?
DeWalt old style radial saw and table
- Thread starter 71SandbugCharger
- Start date
I have a Craftsman model and it comes in handy, depending on the project. I would think that is a good quality machine. I had to replace the carriage bearings on mine as it sat too long before I purchased it.
Mike
YY1
Well-Known Member
I have an extremely similar one.
The lock knobs on mine are white cones.
The height crank is at the front.
Mine is mounted on the matching roll cart.
I use it a LOT.
My model was made between 1954 and 1964.
If I were you, I'd not spend a lot restoring it.
They don't sell for much.
Mine was $25 at a yard sale.
Look on CL. $25 is not a bad price.
The lock knobs on mine are white cones.
The height crank is at the front.
Mine is mounted on the matching roll cart.
I use it a LOT.
My model was made between 1954 and 1964.
If I were you, I'd not spend a lot restoring it.
They don't sell for much.
Mine was $25 at a yard sale.
Look on CL. $25 is not a bad price.
BSB67
Well-Known Member
I was given for free a 1958 Chraftsman RAS about 25 years ago. Truly a beautiful piece of equipment. I did nothing to it. Used it a bunch, then gave it away 3 years ago, still needing nothing.
If you want it, go for it. If the plan is to work on it to flip it, your time would probably be better spent elsewhere.
Also, old non-commercial RASs have accuracy and precision limitations if you’re into that kind of wood working.
If you want it, go for it. If the plan is to work on it to flip it, your time would probably be better spent elsewhere.
Also, old non-commercial RASs have accuracy and precision limitations if you’re into that kind of wood working.
I have an old DeWalt / amf radial arm from the 50s / 60s and a delta table saw from the 90s. Use them 50/50. I would not spend any money restoring the DeWalt. No real market for the old saws. New ones are far more accurate and powerful.
Davefinan
Well-Known Member
I know my dad had one just like it. It introduced me to woodworking and I got hooked. The arm saw is very versatile but later in life I added a table saw to my tools and found I preferred it. When I added a sliding miter saw I hardly used the arm saw anymore.
YY1
Well-Known Member
We also have a 10" sliding, compound miter saw.
I still use the RAS more.
Partially because it's at workbench height vs repeated kneeling, stooping.
...and has a better default support area for the workpiece.
I still use the RAS more.
Partially because it's at workbench height vs repeated kneeling, stooping.
...and has a better default support area for the workpiece.
j-c-c-62
Well-Known Member
First Dewalt Radial arm saw I had was built I believe in 1947?. It was a brute and workhorse. It built many thousands of speaker cabinets.
At the end of the day your right cutting arm would give Popeye a run for the money.
That obviously is a newer smaller version, but I would guess equally as robust.
I bought a newer model Dewalt, but this is where it sat in good working condition for over 10 years before I sold it a few hundred dollars.
The problem is the newer chop saws will do almost the same tasks and you can throw them in the PU by yourself and cost one tenth as much and take up much less room.
It's worth fixing up for your own use, but IMO it is not a high dollar flip as one might think, sadly.
Last edited:
Similar threads
