Front Wheel Hub Bearing Dust Cap Size?

[Moparfiend]

Anyone know what size or part will fit as replacement front disc hub dust caps? My other one is pretty beat up.


These———=>

 

[pnora]

Why not measure what you got then you will know its right.

 

[RemCharger]

Why not measure what you got then you will know its right.

Pre-internet thinking

 

[dodgeboy440]

Anyone know what size or part will fit as replacement front disc hub dust caps? My other one is pretty beat up.


These———=>

View attachment 1789355

You’re Friendly Neighborhood NAPA / Auto Zone / O Reilly etc. Counter Clicker Can Sell You Them IF…..You so inquire ….
Mopar2ya!

 

[gkent]

Dorman 13996. And they're tight! There's no harm in taking a ball peen hammer to the inside and knocking out those dents, you're probably going to do that much damage to the new ones!

 

[dvw]

Straightening them is easy. clamp a ball peen hammer in a vice ball side up.. Lay the cap over the ball end. Then tap with a hammer from the outside of the cap. I've fixed hundreds in my days as a tech. I would never let a car leave with a smashed part. Some of the aftermarket ones fit. And some don't.
Doug

 

[Moparfiend]

Dorman 13996. And they're tight! There's no harm in taking a ball peen hammer to the inside and knocking out those dents, you're probably going to do that much damage to the new ones!

Thanks mate! This is most helpful as it will probably save me the grief of having to make multiple trips as some are too loose. If I went to either Autozone or Oreileys with a dimension they would just stare at me like they always do.

 

[dadsbee]

 

[gkent]

Show off !!

 

[Moparfiend]

View attachment 1789449
View attachment 1789451

Would that be a dust caps setter? If so did you make it?

 

[dadsbee]

Hell, I even got a plastic one with my TSC store log splitter to put the grease caps on !

All you actually need is a pipe cut off to match the collar diameter.

 

[Moparfiend]

Tool envy runs deep in Mopar territory

 

[gkent]

All you actually need is a pipe cut off to match the collar diameter.

Yeah well, where ya gonna find that at 11:30 at night ?!?!?

 

[dadsbee]

Yeah well, where ya gonna find that at 11:30 at night ?!?!?

Me... many places. Shop cut offs beside the mill, crap pipe out in the hangar, the squashed trailer full of 4130 tube beside the hangar, etc... LOL I think 2" ABS drain pipe is the correct size...

 

[dodgeboy440]

Thanks mate! This is most helpful as it will probably save me the grief of having to make multiple trips as some are too loose. If I went to either Autozone or Oreileys with a dimension they would just stare at me like they always do.

I don’t blame them ….
We understand why !

 

[64BEL]

Would that be a dust caps setter? If so did you make it?

I got mine from Rick Ehrenberg on his Ebay site.