Fuel Sending Unit

[RedBeard]

Anyone ever purchased the Golden Star sending units from JEGS? Curious if any good or what others have used.

 

[PurpleBeeper]

In general, it seems the aftermarket sending units aren’t accurate

 

[RedBeard]

In general, it seems the aftermarket sending units aren’t accurate

So any suggestions? Rebuild or ?

 

[Don Frelier]

I have one from Vans in my charger and it works fine.

 

[BeepBeepRR]

I have one from Vans in my charger and it works fine.

Sending Units - Vans Auto

vansauto.com

 

[RedBeard]

I have one from Vans in my charger and it works fine.

K, thanks. Happen to know the manufacturer for these?

 

[PurpleBeeper]

So any suggestions? Rebuild or ?

I searched for an old factory one that worked & found one

 

[Don Frelier]

K, thanks. Happen to know the manufacturer for these?

No sorry I don't.

 

[Swanny]

Holley has a new “floaters” sending unit. Here is the blog on it. https://www.holley.com/blog/post/ho...easy_level_sending_unit_is_changing_the_game/

 

[moparedtn]

Holley has a new “floaters” sending unit. Here is the blog on it. https://www.holley.com/blog/post/ho...easy_level_sending_unit_is_changing_the_game/

Great if you don't mind extensive modification to a stock tank...

 

[moparedtn]

I have one from Vans in my charger and it works fine.

68-70 b-body folks are still out of luck for a decent unit unfortunately.
I do notice that one for yours (thanks for the link @BeepBeepRR ) is apparently made in Taiwan,
so maybe there's hope for that manufacturer?

 

[Swanny]

Great if you don't mind extensive modification to a stock tank...

The install article I read didn’t require modification.

 

[moparedtn]

The install article I read didn’t require modification.

It mounts in the top of the tank.
Our factory sending units....don't.

 

[Swanny]

It mounts in the top of the tank.
Our factory sending units....don't.

Got it - thanks for the clarification.

 

[Pops1967GTX]

I have one from Vans in my charger and it works fine.

I just purchased a unit also , the one from Dante wasn’t accurate and could not be adjusted…

 

[Skatpak]

Yea I have.

 

[Unkle Krusty]

I have the big 25 gallon plastic tank. Plastic is about 1/4 inch thick. Original unit went in the front side about have way down. It was shot. Got a sender from a marine store. It goes in from the top. Top to bottom of tank needed to match the sender. Cut a hole in the tank top, screwed the new sender in place, got a new gauge and it all works.
Later found a gauge that could have worked.

 

[RedBeard]

Yea I have.

Have? And results?