Beautiful Glasstek hood installed. Was way easier than I thought, especially after measuring 5 times and drilling once. Now for paint and final brackets install/tightening.
Glasstek Six Pack Super Bee hood installed
- Thread starter 440beep
- Start date
I would like one for my 70 Bee
33 IMP
Well-Known Member
- Local time
- 9:12 AM
- Joined
- Dec 21, 2017
- Messages
- 13,486
- Reaction score
- 22,430
- Location
- taxifornia,soon 2b Arizona.
Got any shots of the underside of the hood?
(Looks great!).
(Looks great!).
Underside.
33 IMP
Well-Known Member
- Local time
- 9:12 AM
- Joined
- Dec 21, 2017
- Messages
- 13,486
- Reaction score
- 22,430
- Location
- taxifornia,soon 2b Arizona.
Thanks Beep.
Have you got repop brackets to mount the rear pins on? If so, where'd you get em?
Have you got repop brackets to mount the rear pins on? If so, where'd you get em?
Yes, got the rear brackets and pins from Jim’s Mopar Parts in NH. Nice thick steel.
I had Glasstek reinforce the front and it really came out nice. They had a floor model at the Indy swap meet that I could have purchased, but it felt too wimpy. This one is way better.
I had Glasstek reinforce the front and it really came out nice. They had a floor model at the Indy swap meet that I could have purchased, but it felt too wimpy. This one is way better.
Air grabbler
Active Member
I have a very similarly constructed hood from AAR, and it sank in the middle. I recommend taking a few minutes and glassing a brace running fender to fender, right in front of the scoop. I think that would help prevent problems down the road.
Similar threads
- Locked
