Glove box lamp wire fell out

[Edward972]

The light and holder were working correctly and after I removed the glove box to install a new dash plate, the wire that fits into the plastic glove box light wiggled out. I removed the lamp and holder to get a better look at it but cannot figure out how to re-install the wire into the plastic light bulb holder. I see a slot on the side. Has anyone ever re-connected the wire into the housing, and if so, how is it done. Thanks in advance.

 

[Edward972]

OK, figured it out. Of course the little brass end piece just fell off the wire. For those that ever have this issue, I used a small male electrical spade. It fit in the slot, and when you bend back the top tab, the blub will fit in. I checked it on 12 volts, and the spring to turn it on and off via the glove box door, and it works. Once in a while the good guys win.