• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Hard starts and stalling

joseph p.

Well-Known Member
Local time
10:35 AM
Joined
May 15, 2016
Messages
440
Reaction score
474
Location
walnut creek ca
hi guys,would the yellow signal wire on the starter relay cause stalling if it were hanging on a thread of wire??I was changing the relay and I looked at the end of connecter and the wire was hanging on a thread,, literally,,,,went to inspect it and it just fell off.in that state could it make my car stall 2 minutes after warm up,and hard starts after the stall,changed plugs,wires, carb flow good,new solenoid,and new ignition box and ballast resistor,thanks for your attention.69 satellite 383 4bbl electronic ignition.
 
Last edited:
That only triggers the neutral safety relay for the starter. Nothing related to how the engine runs.
maybe check fuel tank venting?
I have has many fuel system issues in the past to where I just by-pass the original fuel system when trouble-shooting.
I rig up an electric pump to pull fuel from a gas can and feed the carb. If it runs good that way, but not with the original fuel system then I know where to start looking.
If the problem is still present, then I can start looking at other areas like ignition and vacuum leaks (assuming the carb is good.)
As for the carb, It could have a bad needle and seat or even a float that has a crack or pinhole allowing fuel into the float both can cause the carb to flood after a few minutes.
Bad or wrong ignition coil could overheat after some time also.
Could also be issues with the primary ignition power, bulkhead connector, alternator brushes and such.
 
Last edited:
thanks my friend,yeah I figured that it wouldn't cause a stall,,yes I'm gonna check the bulk head,and also i cleaned the carb ,Jets,gonna do your recommendation,thanks bud.
 
A bad coil will run for 1-2 minutes then start stumbling and die (also a coil hooked up backwards)
 
thanks my friend,yeah I figured that it wouldn't cause a stall,,yes I'm gonna check the bulk head,and also i cleaned the carb ,Jets,gonna do your recommendation,thanks bud.
Condition of fuel pump pushrod within length spec? Long topic on this in past comments. Search should find topic
 
I had one years ago that would go a lot longer. Guy I worked with who was a mechanic in the 60s was the one who figured it out.
Yeah, intermittent problems like that are the worst... coils are cheap (or free) i carry a spare one with me and points dist :) a slightly bad one will work til it gets good and warm then nothing.. wait a few mins and fires back up. a lot of fun
 
Auto Transport Service
Back
Top