• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

just a little off the back and sides please

now where was I ?

got the back of Challenger welded up and the roof on........ also busted into Jeff's car pretty good

I'm 2 fisted! :drinks:........... which sounds a whole lot better than comparing the situation to a threesome :eek:

IMG_20250115_235809781.jpg
IMG_20250115_235833177.jpg
IMG_20250117_012943686.jpg
IMG_20250117_013009906.jpg
 
Did Jeff want the Quarters replaced,they didnt look bad.
 
quarters are banged up and rusty...... outter wheelhouses / tail panel are nice, drops are ok but not worth salvaging........ it's a little crusty where it matters
 
Did Jeff want the Quarters replaced,they didnt look bad.
Like Mark said they were banged up and weird rust from sitting outside. You could see pin holes all along the edges of the trunk rails. The sheet metal was all bought at Carlisle last summer so he can go to town!
 
Like Mark said they were banged up and weird rust from sitting outside. You could see pin holes all along the edges of the trunk rails. The sheet metal was all bought at Carlisle last summer so he can go to town!
Were was the car from ?
 
Is the foremen on vacation this week?
 
What's your favorite tool/tools for all of that cutting? You sure make short work of it!

it's all there in the pics...... I use a little bit of everything........persistence helps :mad:

plasma cutter
4 1/2 inch wheel of death
3 inch wheel on die grinder
drill
air chisel
hammer/chisel
 
Auto Transport Service
Back
Top