Lisle 22800 Wheel Stud Installer

[themechanic]

I bought this tool to replace the old wheel studs on the rear axles with new studs. Beat the old studs out, cleaned the holes with a bore brush, and installed the new studs in 10 minutes. I highly recommend it and the brush kit.

Lisle 22800 Wheel Stud Installer https://www.amazon.com/dp/B000ETUD2...abc_5PP69P0VW4XXR2CZHJAJ?_encoding=UTF8&psc=1


Clutch bore brush set.

https://m.northerntool.com/shop/too...id=pla-4576992030720219&prdid=43100&gclsrc=ds

 

[GoMango68]

Used the same installer recently and it definitely made quick, and easy work of installing the studs!

 

[YY1]

Looks like a bearing.
What does it actually do?
I usually just start them/locate the splines by hand and then run an "upside down" lug nut with a couple oversize washers down until it seats.

 

[SureGrip]

Looks like a bearing.
What does it actually do?
I usually just start them/locate the splines by hand and then run an "upside down" lug nut with a couple oversize washers down until it seats.

Looks to be the same concept. Start lug place the tool over it, tighten lugnut against tool until the stud is pulled through.

 

[themechanic]

The bearing provides frictionless torque and pulls straight through the center maintaining alignment.

Read the Amazon reviews for a better understanding.

 

[Richard Cranium]

I ordered on & it came in yesterday. I don't have a need for it at the moment, but it seems like a good tool to have.

 

[themechanic]

Be sure to clean up the bearing when done as it gets debris in it from installing studs. Especially, when the hubs or rotors are used and a bit gritty.

 

[wvmarv]

Looks like it would beat the hell out of the stack of washers I always used back in the day.