FOUND Looking for 383

[Splush]

I recently bought a ‘66 Coronet 500 Vert. It was originally a 383 4 spd car. Someone has replaced with a 340. I would love to get it back to factory. I have not had any luck locally so far. Thanks!

 

[BeepBeepRR]

Dont know how close this is to you. Also don't know anything about it. But here ya go.

Dodge motor - auto parts - by owner - vehicle automotive sale - craigslist

383 Dodge motor machined 4 years ago not put together there's an engine stand cherry picker 2 transmissions too many new parts to list anything that goes with the motor goes with the buyer, tools...

indianapolis.craigslist.org

 

[Mopar Hunter]

Dont know how close this is to you. Also don't know anything about it. But here ya go.

Dodge motor - auto parts - by owner - vehicle automotive sale - craigslist

383 Dodge motor machined 4 years ago not put together there's an engine stand cherry picker 2 transmissions too many new parts to list anything that goes with the motor goes with the buyer, tools...

indianapolis.craigslist.org

That’s not a 383, the distributor is in the back. The other two pictures are transmissions.

 

[Nirvana]

That’s a 318, not a 383.

 

[not so famous bob]

I recently bought a ‘66 Coronet 500 Vert. It was originally a 383 4 spd car. Someone has replaced with a 340. I would love to get it back to factory. I have not had any luck locally so far. Thanks!

facebook...

 

[66 Cornpicker]

Splush, I have a 70 383 & 727 never been apart original cond. I'm in Ohio just south of Cleveland for 1500. Thanks for looking

 

[4vnut]

I have a 1960 cast 361 with factory 383 bore. Block only $250.00. Iron heads and 727's also available.

 

[65CopCar]

I have a complete 66 383 that needs a rebuild. Not sure if you could pry it out of my hands or not. But I am also only 2 hours away.

 

[Mopar Hunter]

@GTX JOHN

 

[POMONAMISSEL]

need the bell housing as well , sbm and bbm are different bolt patterns . so for the flywheel to fit , it's a 130 t , you need a 130t flywheel bbm bellhousing .

 

[GTX JOHN]

I have a 1960 cast 361 with factory 383 bore. Block only $250.00. Iron heads and 727's also available.

The 361 has a way way smaller bore. (4.125)
I would not every try to over bore them near that far to 383. (4.25)
That is a huge .125 difference in my opinion

 

[Moparguy59]

Need to have the pilot go in the crankshaft for a 4speed

 

[POMONAMISSEL]

i've got a 66 383 from a charger . pulled it years ago . it's sitting in my barn out here in calif .

 

[Splush]

Thanks everyone, I have found one that I am picking up next weekend. It is out of a '66 Coronet!