Motor Wheel Sypders.....dayum....

[YY1]

I have a stash of both OEM and early repro centers.
Whoever did the repros did an outstanding job.
The only way I could tell is the repros have not been used and the holes to hold them on aren't tapped.
Unfortunately, the OEM designers didn't appear to like "dish" and almost all have almost none.
If a wheel falls over and lands on the front, the center gets dented.
Many are flat spotted from repeated falls.
Too bad, as they look great with a moderate deep dish.

 

[chargervert]

It sure would be nice if someone reproduced them! I should have bought a set of recall wheels when they were still available!

 

[33 IMP]

It sure would be nice if someone reproduced them! I should have bought a set of recall wheels when they were still available!

Recalls WERE repoped, many years ago. Apparently not enough of them sold, or they were too expensive. If I recall they weren't "reasonably priced".

 

[chargervert]

They were about $1200 to $1500 per set of four.

 

[33 IMP]

They were about $1200 to $1500 per set of four.

....when a set of torque thrusts were probably under $400.

 

[chargervert]

....when a set of torque thrusts were probably under $400.

Who knew that they were going to stop making them though.

 

[72redbird]

Holy smokes!!

 

[YY1]

They were about $1200 to $1500 per set of four.

...and that was late 80's/early 90's money.

 

[chargervert]

...and that was late 80's/early 90's money.

I am talking about the reproduction recall wheels,not an original set.

 

[YY1]

Me too.