Need new hood adjusters.

[bubba68]

I found good used ones but really would like to find some new ones. I know they used these till mid 80's. Part # is 4113435 but discontinued. I think new core supports have them so someone is making them. Anyone have source? T

Thanks Larry J

 

[bubba68]

Anyone??

 

[bubba68]

Someone out there has been down this road??

 

[Richard Cranium]

I've never seen them separate from the core support. If you have a pair of used ones, why not just bead blast them,, run a thread chaser in them and weld them on?

 

[bubba68]

That was the intention but the car has come out so nice its hard to put used ones on. No one noticed they were not there until paint was done and the hood went on. It had a 6 pack hood on it and thats where they had the hood pins. The used ones I have do not have any prongs. If I could find someone that would cut a pair out of a core support still stamped into the core (if that makes since) I think I could get them out complete then blast and paint them.

 

[Speedbird]

Used only.
You have a number. That's more than I ever found.
Someone really, really should repo them.
http://www.forbbodiesonly.com/mopar...or-hood-stop-adjusters.106352/#post-910390834

For resto mod purposes, I'm resorting to fender washers and nuts.

 

[bubba68]

I have not seen a core support from AMD but I assume they have them stamped on the core? If so there has to be source for them? Maybe I will try them?