Rear Sump Oil Pan, Pickup tube, support bolt on Hellcrate Motor

[Mheiron]

So I'm in the process of converting a new hellcrate motor to a rear sump pan. I have the Milodon kit and everything seems to fit except:

Has anyone encountered this extended bolt previously? It supported the original stock oil pickup tube. Its also a main cap bolt on the#1 bearing and I believe it must have been torque-to-yield and shouldnt be re-used. A replacement should be installed on the #3 cap to support the new oil pickup tube IMHO.

I'm reluctant to re-use the bolt without some due diligence.

Does anyone know of any source for a new support bolt or some other solution? Frog Jones at Mopar Performance has been looking but no success so far.

Thanks in advance for any help or advice.

 

[srw-409]

Is this what you’re looking for?

https://bouchillonperformance.com/inc/sdetail/3030/17489

 

[Mheiron]

Is this what you’re looking for?

https://bouchillonperformance.com/inc/sdetail/3030/17489

View attachment 1118843

Thats it. Thanks. Why they dont add that to the kit is another question!

 

[5.7 hemi]

A lot of swaps just swap the bolt with #3 if I remember correctly.

 

[Mheiron]

To complete the thread for future searches:

Spoke with Randy at Bouchillon Performance and it turns out that thats not the correct part for a hellcat motor. It fits the other gen III hemis.

The correct part for a hellcat is 62RA205AA.