Replacement body panels question.

[ed-shot500]

Anyone know of anywhere that makes reproduction metal body panels for 73-75 b Bodies specifically roadrunners and or satellites I've checked Google and haven't really found anything

 

[Dodge33]

I am pretty sure that Murry Park in Tiffin, Ohio has or had quite a bit of body cutoffs from Arizona brought to him, sometime ago. So you should be able to get his contact information through Google. Goodluck.
He is a heck of a nice guy too!

 

[Hilljack68]

I've contacted Murray's a few times. Had to leave a message, and he has never returned a call. Disappointing.

 

[Fm3 Dart]

Anyone know of anywhere that makes reproduction metal body panels for 73-75 b Bodies specifically roadrunners and or satellites I've checked Google and haven't really found anything

No exterior body panels are made for the 73-74 Plymouth B bodies. Some of the inner panels carry over from the 71-72's and are being reproduced. Auto metal direct makes interior floors, trunk floors, trunk floor extensions, inner and outer wheelhouses for the 71-72 that will fit in the 73-74 B bodies. AMD did make lower rear quarter patch panels at one time, but those were discontinued.

As for the 75 -78 2 doors, again, no exterior panels are available, but the AMD interior floors, inner wheel houses and trunk floor for the 71-72 can be made to fit with a few modifications.

 

[ed-shot500]

No exterior body panels are made for the 73-74 Plymouth B bodies. Some of the inner panels carry over from the 71-72's and are being reproduced. Auto metal direct makes interior floors, trunk floors, trunk floor extensions, inner and outer wheelhouses for the 71-72 that will fit in the 73-74 B bodies. AMD did make lower rear quarter patch panels at one time, but those were discontinued.

As for the 75 -78 2 doors, again, no exterior panels are available, but the AMD interior floors, inner wheel houses and trunk floor for the 71-72 can be made to fit with a few modifications.

Damn so what does one do then ? Besides just give up on the car? Cus this is what I'm dealing with ATM

 

[gdrill]

What you see is the tip of the iceberg. Hand fab is a big part of saving a car, but how far are you willing to go? What is underneath?

 

[eldubb440]

I've never seen a hinge pillar rot like that........

I'm sure there are a few nice survivor cars out there that can be had for cheap and easily made road worthy

 

[chargervert]

I5 would be far cheaper to get another body from out west than to do the metal work on this one. I have heard of people using 70s Dodge truck front fenders to repair the rear wheel well sections on 73/74 Plymouth b body cars.

 

[moparsaver]

That’s a lot of rot. Florida car… parked near the ocean?

 

[RemCharger]

Damn so what does one do then ? Besides just give up on the car? Cus this is what I'm dealing with ATM

View attachment 1508544

View attachment 1508545

View attachment 1508546

As stated , you make pieces and weld them in as they've done for a century.
If it doesn't sound easy, it's because it's not.

 

[rm2173!]

i have parts for that car if u are interested