turn signal lever/cancel cam broken

[djais1801]

I have had lots of play in the turn signal lever...I could use it and would have to manually return on right turns...the left turn signal returns.
However, yesterday I noticed that when putting the "right" turn signal on, it would fall...I had to hold it upright to put on the right turn indicator..

could this just be the cancel cam?

 

[67 coronet]

ya.if the ends break off,very common,the lever will just flop around loose.drops to the gravity side.

 

[djais1801]

is that an easy swap...or are there wires soldered to the cam?

ya.if the ends break off,very common,the lever will just flop around loose.drops to the gravity side.

 

[okiemopar]

You will have to pull the wheel off and I think the cam that you get now has to be soldered on, I just put the whole wiring harness in mine. Good Luck Ronnie

 

[djais1801]

thanks!

 

[bandit]

I have seen where you can just get the plastic portion of the cam, but if you buy the whole thing, it should come wired already with a plug on the end and you just have to snake the wire through the stearing column and it plugs in by the base. Did mine last year. Just borrow a steering wheel puller from autozone and the rest is easy.