Search results for query: *

Hi gents, been awhile. Car needs excessive starting turns when sitting for more than a couple of days especially in the winter months. It's been cold this year too. Summer not as bad where it may be affected after sitting more than a week or two. I saw this Youtube video where someone...

If someone made them I would buy a few sets! I like them on the 68 Chargers. A 3D printer would make short work out of them!

I have 63.5” belts on my car but it has a round back alternator and I think yours may have a square back one. The adjustment bolt holes may be located differently in the cases. My pulley may be an oddball as it measures 2.7” dia. My adjusting bolt is in the intended hole I believe. It...

Thats Great Mike :thumbsup:

Mine tried that buy her own car, I disapproved of the vehicle 22Grand pile of crap L series based on a little Alfa Romeo. I told her it was all hers... yup you know how it goes. I wasn’t going to touch the thing or drive it... If I drive that damn thing I’m constantly getting told how to drive...

Just my $0.02…just did this on my stock 383 to fix an oil leak. Was confused by all the gaskets and o-rings, so talked to a local Mopar engine builder who said use Permatex “The Right Stuff” around ports on heads, no gasket then set the valley pan. Then no gasket between intake manifold and...

Hi - were you able to install this Malwood hydraulic kit with your engine in the car? I've got a '70 Roadrunner and I'm getting ready to convert from automatic to 4-speed and would like to install a hydraulic clutch at the same time. Didn't know if it would require pulling my engine to do this...

Hi - were you able to install this Malwood hydraulic kit with your engine in the car? I've got a '70 Roadrunner and I'm getting ready to convert from automatic to 4-speed and would like to install a hydraulic clutch at the same time. Didn't know if it would require pulling my engine to do this...

Jeffs car must of been sitting in a river bed,was it factory undercoated? Just shows us all you never know what we are getting into. Hope the rails are good.

:rofl:

Gee, What is that, the whole US strategic petroleum reserve? How many quarts does that thing hold?

Looking at the inner fender and frame at the access hole there is a notch in the frame that a new weld in bracket tab will fall into if the frame hasn't been modified. Iv'e done a couple of them.

Swinging p/u with external lines.Pick up is 1/4 inch off the bottom.

Why wouldn't they clean it up before trying to flip it for 9k!

Total disorientation!

NOT MINE $9,000 Lexington, North Carolina post id: 7819453841 posted: 15 days ago updated: 7 days ago 1968 Plymouth Fury III - Big Block 383 | Rare Find For sale: A classic 1968 Plymouth Fury III with the original big block 383 engine and automatic transmission. This car comes with...

Wives are never happy with broken down cars!

I remember when hemi guys with headers were paying a fortune for the stock manifolds that everybody threw away.

Looking on converting my 69 Charger to a 4 speed. Have all the parts, but need info on locating the clutch bell crank bracket. The engine is not installed so I have plenty of room to work. i found the bracket, but no measurements on location included. Thanks for all the help. looking on...

No, that’s not how it works. You feel like you’re moving in directions that you aren’t, so you move the flight controls in the wrong direction(s).