62 Belvedere 318 poly granny cruiser (one day i hope)

[icetech]

That will make a nice stroker. It is probably just rusted up a bit.

It's soo slimed... whole front of the motor looks like 1" of grease from years of leaking covers.. factory 4bbl which i figured they would have dropped by 85.. gonna try to get some money out of the heads/intake if i can.. $50 on market place maybe... see if i can sell some of the crap to make up the cost of the block

 

[toolmanmike]

It's soo slimed... whole front of the motor looks like 1" of grease from years of leaking covers.. factory 4bbl which i figured they would have dropped by 85.. gonna try to get some money out of the heads/intake if i can.. $50 on market place maybe... see if i can sell some of the crap to make up the cost of the block

Good plan.

 

[icetech]

K.. block showed up... nasty outside, pretty clean inside, no sludge but haven't pulled the pan yet.. has some rust in a couple of cyls but not TOO bad... i was kinda hoping the cyls were better and i might have just used it as is... i need to figure a way to get this to a machine shop now.. (i work too much)

Ohh.. and it's a 1985 block but not roller